期刊名称：STRUCTURAL SAFETY
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
|
Structural Safety is an international journal devoted to integrated risk assessment for a wide range of constructed facilities such as buildings, bridges, earth structures, offshore facilities, dams, lifelines and nuclear structural systems. Its purpose is to foster communication about risk and reliability among technical disciplines involved in design and construction, and to enhance the use of risk management in the constructed environment. All aspects of quantitative safety assessment are of interest:
loads and environmental effects;
material properties;
prediction of response and performance;
treatment of human error and engineering judgment;
quality assurance/control;
and techniques of decision analysis and risk management. |
 |
Instructions to Authors
Submission of papers:
By Mail: Manuscripts (1 original and 2 copies) accompanied by a covering letter should be sent to the submission address. Only after final acceptance a disk/CD ROM needs to be sent with the hardcopy.
Online: For online submission upload one copy of the full paper including graphics and all figures as graphics file separately at the online submission site http://www.elsubmit.com/esubmit/strucs
Submission address:
Professor Bruce R Ellingwood,
School of Civil and Environmental Engineering,
Georgia Institute of Technology,
Atlanta, GA 30332-0355,
USA
Submission Language: English
Types of contributions: Original research papers, reviews, short communications.
Editor requirement: If you are submitting online, be sure to check the PDF created by the submission system IN DETAIL, as there could be small conversion problems. Failure to do so can cause delay to the reviewing process and you will be asked to submit again.
Corresponding author: Clearly indicate who is willing to handle correspondence at all stages of refereeing and publication, also post-publication. Ensure that telephone and fax numbers (with country and area code) are provided in addition to the e-mail address and the complete postal address. Full postal addresses must be given for all co-authors. Please consult a recent journal paper for style if possible.
Original material: Submission of an article implies that the work described has not been published previously (except in the form of an abstract or as part of a published lecture or academic thesis), that it is not under consideration for publication elsewhere, that its publication is approved by all authors and that, if accepted, it will not be published elsewhere in the same form, in English or in any other language, without the written consent of the Publisher.
Detailed instructions on manuscript preparation and artwork instructions can be found below. The editor reserves the right to return manuscripts that do not conform to the instructions for manuscript preparation and artwork instruction, as well as paper that do not fit the scope of the journal, prior to refereeing.
Back to the contents list
Manuscript Preparation:
General:
Editors reserve the right to adjust style to certain standards of uniformity. Original manuscripts are discarded one month after publication unless the Publisher is asked to return original material after use. An electronic copy of the manuscript on disk should accompany the final accepted version if submitted in hardcopy. Please use Word, Word Perfect or LaTeX files for the text of your manuscript. (For further information about LaTex submission, please go to http://www.Elsevier.com/locate/latex.)
Back to contents list
Structure:
Follow this order when typing manuscripts: Title, Authors, Affiliations, Abstract, Keywords, Main text, Acknowledgements, Appendix, References, Figure Captions and then Tables. For submission in hardcopy, do not import figures into the text - see Illustrations. For online submission, please supply figures imported into the text AND also separately as original graphics files. Collate acknowledgements in a separate section at the end of the article and do not include them on the title page, as a footnote to the title or otherwise.
Back to the contents list
Text Layout:
Use double spacing and wide (3 cm) margins. (Avoid full justification, i.e., do not use a constant right-hand margin.) Ensure that each new paragraph is clearly indicated. Present tables and figure legends on separate pages at the end of the manuscript. If possible, consult a recent issue of the journal to become familiar with layout and conventions. Number all pages consecutively, use 12 or 10 pt font size and standard fonts. If submitting in hardcopy, print the entire manuscript on one side of the paper only.
Back to the contents list
Corresponding author:
Clearly indicate who is willing to handle correspondence at all stages of refereeing and publication, also post-publication. Ensure that telephone and fax numbers (with country and area code) are provided in addition to the e-mail address and the complete postal address. Full postal addresses must be given for all co-authors. Please consult a recent journal paper for style if possible.
Back to the contents list
Abstract:
A self-contained abstract outlining in a single paragraph the aims, scope and conclusions of the paper must be supplied.
Back to the contents list
Keywords:
Immediately after the abstract, provide a maximum of six keywords (avoid, for example, 'and', 'of'). Be sparing with abbreviations: only abbreviations firmly established in the field may be eligible. It is suggested that you pick the keywords from the EJC thesaurus.
Back to the contents list
Units:
Follow internationally accepted rules and conventions: use the international system of units (SI). If other quantities are mentioned, give their equivalent in SI.
Back to the contents list
Maths:
Number consecutively any equations that have to be displayed separately from the text (if referred to explicitly in the text).
References:
All publications cited in the text should be presented in a list of references following the text of the manuscript.
Text: Indicate references by number(s) in square brackets in line with the text. The actual authors can be referred to, but the reference number(s) must always be given.
List: Number the references (numbers in square brackets) in the list in the order in which they appear in the text.
Examples:
Reference to a journal publication:
[1] Van der Geer J, Hanraads JAJ, Lupton RA. The art of writing a scientific article. J Sci Commun 2000;163:51-9.
Reference to a book:
[2] Strunk Jr W, White EB. The elements of style. 3rd ed. New York: Macmillan; 1979.
Reference to a chapter in an edited book:
[3] Mettam GR, Adams LB. How to prepare an electronic version of your article. In: Jones BS, Smith RZ, editors. Introduction to the electronic age, New York: E-Publishing Inc; 1999, p. 281-304
Note shortened form for last page number. e.g., 51-9, and that for more than 6 authors the first 6 should be listed followed by 'et al.'
Back to the contents list
Colour Costs and Queries:
For colour illustrations, a colour printing fee is charged to the author per colour page. Further information concerning colour illustrations and costs is available from Author Support at authorsupport@elsevier.ie, and at http://authors.Elsevier.com/locate/authorartwork .
Back to the contents list
FREE ONLINE COLOUR
If, together with your accepted article, you submit usable colour and black/white figures then Elsevier will ensure, at no additional charge, that these figures will appear in colour on the web (e.g., ScienceDirect and other sites) regardless of whether or not these illustrations are reproduced in colour in the printed version. ' Usable' means the formats comply with our instructions. See the information about Illustrations at http://authors.Elsevier.com/locate/authorartwork . For colour illustrations in the print journal see colour costs above.
Back to the contents list
Tables:
Tables should be numbered consecutively and given suitable caption and each table is laid out on a new page. No vertical rules should be used. Tables should not duplicate results presented elsewhere in the manuscript (for example, in graphs). Footnotes to tables should be typed below the table and should be referred to by superscript lowercase letters.
Back to the contents list
Supplying final accepted text on disk:
NOTE: This applies only for authors who have submitted in hardcopy. Once the paper has been accepted by the editor, an electronic version of the text should be submitted together with the final hardcopy of the manuscript. The electronic version must match the hardcopy exactly. We accept most wordprocessing formats, but Word, WordPerfect or LaTeX (see also http://www.Elsevier.com/locate/latex) is preferred. Always keep a backup copy of the electronic file for reference and safety. Label disk with your name, journal title, and software used. Save your files using the default extension of the program used. Electronic files can be stored on 3? inch diskette, ZIP-disk or CD (either MS-DOS or Macintosh).
Back to the contents list
Notification:
Authors will be notified of the acceptance of their paper by the editor. The Publisher will also send a notification of receipt of the paper in production.
Back to the contents list
Copyright:
All authors must sign the Transfer of Copyright agreement before the article can be published. This transfer agreement enables Elsevier to protect the copyrighted material for the authors, but does not relinquish the authors' proprietory rights. The copyright transfer covers the exclusive rights to reproduce and distribute the article, including reprints, photographic reproductions, microfilm or any other reproductions of similar nature and translations. Authors are responsible for obtaining copyright from the holder permission to reproduce any figures for which copyright exists.
For more information please go to our copyright page http://authors.elsevier.com/quickguide"target="_blank.
Back to the contents list
PDF Proofs:
One set of page proofs in PDF format will be sent by e-mail to the corresponding author, to be checked for typesetting/editing. The corrections should be returned within 48 hours. No changes in, or additions to, the accepted (and subsequently edited) manuscript will be allowed at this stage. Proofreading is solely the author's responsibility. Any queries should be answered in full. Please only correct factual errors, or errors introduced by typesetting.
For more information on proofreading please go to our proofreading page http://authors.elsevier.com/quickguide"target="_blank. Please note that once your paper has been proofed we publish the identical paper online as in print.
Back to the contents list
Author Benefits:
No page charges: Publications in this journal is free of charge.
Free Offprints: Twenty-five offprints will be supplied free of charge. Corresponding authors will be given the choice to buy extra offprints before printing of the article. Authors who pay for colour illustrations will receive an extra fifty offprints free of charge.
Author Discount: Contributors to Elsevier journals are entitled to a 30% discount on all Elsevier books. See http://www.elsevier.com/homepage/booksbutler"target="_blank for more information.
Back to the contents list
Online Paper Tracking:
Authors can track the status of their accepted paper online at http://authors.elsevier.com using the reference supplied by the Publisher.
Back to the contents list
Author enquiries:
All author enquiries should be made to: authorsupport@elsevier.ie
Useful links:
Editorial Board
|
Editor-in-Chief:
|
|
|
B. Ellingwood, School of Civil and Environmental Engineering, Georgia Institute of Technology, Atlanta, GA 30332-0355, USA
Fax: 404-894-2278
Email:bruce.ellingwood@ce.gatech.edu
|
|
Editorial Board:
|
|
|
G. Augusti, Rome, Italy
|
|
|
D.I. Blockley, University of Bristol, UK
|
|
|
F. Casciati, Pavia, Italy
|
|
|
K.C. Chou, Mankato, MN, USA
|
|
|
R.B. Corotis, Boulder, CO, USA
|
|
|
A. Der Kiureghian, Berkeley, CA, USA
|
|
|
O. Ditlevsen, Lyngby, Denmark
|
|
|
L.E. Esteva, Mexico, DF, Mexico
|
|
|
R. Foschi, Vancouver, BC, Canada
|
|
|
D. Frangopol, Boulder, CO, USA
|
|
|
M. Grigoriu, Ithaca, NY, USA
|
|
|
A.M. Hasofer, Kensington, NSW, Australia
|
|
|
Y. Hu, Harbin, China
|
|
|
A. Kareem, Notre Dame, IN, USA
|
|
|
T. Katayama, Ibraki, Japan
|
|
|
M. Matsuo, Nagoya, Japan
|
|
|
R. Melchers, Newcastle, Australia
|
|
|
T. Moan, Trondheim, Norway
|
|
|
F. Moses, Cleveland, OH, USA
|
|
|
Y. Murotsu, Sakai, Japan
|
|
|
J.W. Murzewski, Krakow, Poland
|
|
|
A. Naess, Trondheim, Norway
|
|
|
A. Nowak, Ann Arbor, MI, USA
|
|
|
R.R. Rackwitz, Munich, Germany
|
|
|
J.D. Riera, Porto Alegre, Brazil
|
|
|
G.I. Schuëller, Innsbruck, Austria
|
|
|
R.G. Sexsmith, Vancouver, Canada
|
|
|
M. Shinozuka, Princeton, NJ, USA
|
|
|
E. Simiu, National Institute of Standards and Technology, Gaithersburg, MD, USA
|
|
|
P.D. Spanos, Rice University, Houston, TX, USA
|
|
|
W.H. Tang, Hong Kong University of Science & Technology, Sai Kung, Hong Kong
|
|
|
P. Thoft-Christensen, Aalborg, Denmark
|
|
|
S.A. Timashev, Ekaterinburg, Russia
|
|
|
E.H. Vanmarcke, Princeton University, NJ, USA
|
|
|
A.C.W.M. Vrouwenvelder, Delft, The Netherlands
|
|
|
Y.K. Wen, Urbana, IL, USA
|
|
|
W.-Q. Zhu, Hangzhou, China
|
|
Book Reviews
|
|
|
S.G. Reid, University of Sydney, Australia
|
|
Founding Editor:
|
|
|
E.H. Vanmarcke, Princeton, NJ, USA
|
|
刊名字顺( Alphabetical List of Journals):
返回页首 