期刊名称：JOURNAL OF VIBRATION AND ACOUSTICS-TRANSACTIONS OF THE ASME
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
|
The purpose of the Journal of Vibration and Acoustics is to serve as a vehicle for the communication of original research results of permanent interest in the area of application of physical principles of acoustics to the solution of noise control problems, and the uses of acoustics in industrial and medical application. Papers published by the journal are full length articles of considerate depth. The journal also presents Tech Briefs, which are intended to serve as a means for the rapid communication of recent developments in an abridged form. Specific topic areas covered include: vibration suppression;non-linear vibration; modal analysis; structural dynamics and control; mechanical signatures; rotor dynamics; vibration control; passive and active damping; random vibration; acousic emission; active noise control; machinery noise; flow induced noise and vibration; and machinery dynamics.
|
|
Instructions to Authors
One purpose of the Society is to disseminate technical information of permanent interest through the publication of a series of Transactions quarterlies.
Papers selected for publication in the ASME Transactions are subject to a voluntary page charge of $75 per journal page, which will be invoiced, through the author, to the author's company, institute, or agency. Publication is not dependent upon payment of the voluntary page charge. As of January 2000, the standard length for an ASME Journal paper is nine (9) printed pages. Should the paper exceed this length, the lead author will be assessed a mandatory excess-page charge of $200 per page for each page over nine pages. This charge will be included, as a separate item, on the same invoice as the voluntary page charge. Payment is mandatory and does not entitle the author to free reprints. Such a paper will not be published until the author agrees to honor the mandatory page charge.
The text of an ASME paper should not exceed nine (9) printed pages in a journal. This corresponds to 42-45 total manuscript pages, typed double-spaced with 10 pt. type, with each figure counting as a page. A Technical Brief should not exceed two and a half journal pages. Discussions should not exceed 500 words, and closures normally should not exceed 250 words per discussion.
Manuscripts should be submitted online for the Journal of Vibration and Acoustics. Please visit http://journaltool.asme.org for more details. Guidelines for manuscript styling and preparation are provided at the site.
Each manuscript must be accompanied by a statement that it has been neither published nor submitted for publication, in whole or in part, either in a serial, professional journal or as a part in a book which is formally published and made available to the public. ASME meeting preprints and articles included in symposium volumes for symposia (sponsored or co-sponsored by ASME) are not considered as prior publication. The journals do not accept multi-part manuscripts. Each paper should be capable of being reviewed independently of other submissions by the same author(s).
All manuscripts submitted to ASME must use SI (Metric) Units in text, figures, or tables. In addition to SI units, English units may be included parenthetically.
All mathematical expressions should be included in the manuscript. Care should be taken to distinguish between capital and lowercase letters, between zero (0) and the letter (O), between the numerical (1) and the letter (l), etc. Mathematical expressions should fit into a single column when set in type. Equations that might extend beyond the width of one column (fractions that should not be broken or long expressions enclosed in parentheses) should be rephrased to go on two or more lines within column width. Fractional powers are preferred to root signs and should always be used in more elaborate formulas. The solidus (/) should be used instead of the horizontal line for fractions whenever possible. Numbers that identify mathematical expressions should be enclosed in parentheses. Refer to equations in the text as "Eq. (1),' etc., or "Equation (1),' etc., at the beginning of a sentence.
A nomenclature defining symbols should be included, except for brief communications, like Technical Briefs, where symbols are normally identified in the text.
Brief tables may be included in the text of the manuscript, but larger tables (more than six lines) should be created separately and assembled with the figures at the end of the manuscript. A separate list of figure captions should be included in the manuscript. Color graphics are included in the electronic version of the journal at no additional cost to the author; however, for full color in print authors will be assessed the additional charges.
All references should be listed at the end of the text in the order in which they are cited (not alphabetical). References should include date of publication, full title, full name of source, and inclusive page numbers. References should be cited within the text in numerical order according to their order of appearance. The numbered reference citation should be enclosed in brackets, e.g., "It was shown by Prusa [1] that the width of the plume decreases under these conditions." In the case of two citations, the numbers should be separated by a comma [1,2]. In the case of more than two reference citations, the numbers should be separated by a dash [5-7]. Acceptable references include: journal articles, dissertations, published conference proceedings, numbered paper preprints from conferences, books, reports available from the U.S. Government, submitted articles if the journal is identified, and private communications.
If the voluntary page charge has been honored, 100 reprints are provided to the author(s) upon publication of the paper at no additional cost. Reprints may be ordered from the Technical Publishing Department, ATTN: Marisol Andino, The American Society of Mechanical Engineers, Three Park Avenue, New York, NY 10016-5990. A reprint order form will be sent to the corresponding author after the article is typeset. All orders must be prepaid.
Manuscripts should be submitted online at: http://journaltool.asme.org. Please address all communications to: Editor, Professor Lawrence A. Bergman, Department of Aeronautical and Astronautical Engineering, University of Illinois at Urbana-Champaign, Urbana, IL 61801, P: 217-333-4970, F: 217-244-0720, E: lbergman@uiuc.edu
Editorial Board
EDITORS
LAWRENCE A. BERGMAN
ASSISTANT TO EDITOR
LINDA CONWAY
PAST EDITORS
F. EHRICH
T. CONRY
DANIEL J. INMAN
DESIGN ENGINEERING DIVISION
ASSOCIATE EDITORS
J. CUSUMANO (2003)
S. DYKE (2005)
G. FLOWERS (2005)
J. GINSBERG (2005)
M. I. FRISWELL (2004)
R. P. S. HAN (2003)
J. MAIN (2005)
D. QUINN (2005)
R. PARKER (2005)
C.H. TAN (2004)
J. WICKERT (2003)
NOISE CONTROL & ACOUSTICS DIVISION
R. KELTIE (2004)
R. OHAYON (2003)
BOARD ON COMMUNICATIONS
Chair and Vice-President
O. OCHOA
OFFICERS OF THE ASME
President, REGINALD VACHON
Executive Director, VIRGIL R. CARTER
Treasurer, R.E. NICKELL
PUBLISHING STAFF
Managing Director, Engineering
TOM G. LOUGHLIN
Director, Technical Publishing
PHILIP DI VIETRO
Manager Journals
JOAN MERANZE
Production Coordinator
RAY RAMONAS
Production Assistant
MARISOL ANDINO
Transactions of the ASME, Journal of Vibration and Acoustics (ISSN 1048-9002) is published quarterly (Jan., April, July, Oct.) by The American Society of Mechanical Engineers, Three Park Avenue, New York, NY 10016-5990.
POSTMASTER:
Periodicals postage paid at New York, NY and additional mailing offices.
| Send address changes to: |
Transactions of the ASME, Journal of Vibration and Acoustics
c/o ASME International
22 Law Drive, Box 2300
Fairfield, NJ 07007-2300 |
Changes of address must be received at Society headquarters seven weeks before they are to be effective. Please send old label and new address.
Statement from By-Laws
The Society shall not be responsible for statements or opinions advanced in papers or . . . printed in its publications (B7.1, Para. 3).
Copyright 2003 by The American Society of Mechanical Engineers.
For authorization to photocopy material for internal or personal use under those circumstances not falling within the fair use provisions of the Copyright Act, contact the
Copyright Clearance Center (CCC)
222 Rosewood Drive
Danvers, MA 01923
tel: 978-750-8400
www.copyright.com
Request for special permission or bulk copying should be addressed to Reprints/Permission Department.
Download
Abstracted and Indexed Journals PDF
Tax Registration: 2126148048
| Contact the Editor: |
Professor Lawrence A. Bergman
Dept. of Aero. & Astro. Engrg
Univ of Illinois at Urbana-Champaign
104 South Wright St.
Urbana, IL 61801
P: 217-333-4970
F: 217-244-0720
E: lbergman@uiuc.edu |
| 
刊名字顺( Alphabetical List of Journals):
返回页首 