期刊名称：JOURNAL OF NON-CRYSTALLINE SOLIDS
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
|
The Journal of Non-Crystalline Solids publishes review articles, research papers, and Letters to the Editor on oxide and non- oxide glasses, amorphous semiconductors, non-crystalline films such as those prepared by vapor-deposition, glass ceramics and glassy composites. Papers on the liquid state are also included in so far as the properties of the liquid are relevant for the formation of the solid.
The journal publishes "Letters to the Editor" with a guarantee of publication within 3 months after acceptance of the manuscript
|
|
Instructions to Authors
Submission of papers
Manuscripts (one original + two copies), should be sent to the Editor or any one of the regional editors. The address of the Editor is as follows:
Professor J.H. Simmons
Editor, Journal of Non-Crystalline Solids
Arizona Materials Laboratory
4715E Fort Lowell Road #143, Tucson AZ 85712, USA
E-mail: info@jncs.org (general information); eMS@jncs.org (electronic manuscript submission)
Original material: On submission, authors are asked to confirm that the manuscript is not being simultaneously considered for publication elsewhere and that all authors have approved the manuscript and take full responsibility for its contents and so state in their letter of transmittal.
Types of contributions
Original research papers, reviews, letters to the editor and commentaries are welcome. They should contain an abstract (of up to 200 words) and a Conclusions section which, particularly in the case of theoretical papers, translates the results into terms readily accessible to most readers.
Letters should be no longer than six double-spaced typed pages. They will be given priority in both the refereeing and production processes. The faster production schedule will preclude sending proofs of letters to authors.
Manuscript preparation
All manuscripts should be written in good English. The paper copies of the text should be prepared with double line spacing and wide margins, on numbered sheets. See notes opposite on electronic version of manuscripts.
Structure. Please adhere to the following order of presentation: Article title, Author(s), Affiliation(s), Abstract, PACS codes (click here for PACS codes), Main text (Introduction; Experimental procedures or constraints on theory; Results; Discussion; Conclusion. Sections and sub-sections must be clearly numbered according to the Journal style), Acknowledgements, Appendices, References, Figure captions, Tables.
Corresponding author. The name, complete postal address, telephone and fax numbers and the e-mail address of the corresponding author should be given on the first page of the manuscipt.
References. References to other work should be consecutively numbered in the text using square brackets and listed by number in the Reference list. Please refer to past issues of the Journal for examples.
Symbols/Units: Authors should follow the Symbols and Units Nomenclature Commission of the I.U.P.A.P. (Physica 146A (1987) 1-68).
Illustrations (figures)
Illustrations should also be submitted in triplicate: one master set and two sets of copies. The line drawings in the master set should be original laser printer or plotter output or drawn in black india ink, with careful lettering; lettering should be 2 mm in height after reduction for printing. The photographs should be originals, with somewhat more contrast than is required in the printed version. The top edge should be indicated on the back. They should be unmounted unless part of a composite figure. Any scale markers should be inserted on the photograph itself, not drawn below it.
Colour plates. Figures may be published in colour, if this is judged essential by the Editor. The publisher and the author will each bear part of the extra costs involved. Further information is available from the publisher.
Classification codes/keywords
Please supply one to four classification codes (PACS and/or MSC) that describe the content of your article in more detail.
After acceptance
Notification. You will be notified by the Editor of the journal of the acceptance of your article and invited to supply an electronic version of the accepted text, if this is not already available.
Copyright transfer. In the course of the production process you will be asked to transfer the copyright of the article to the publisher. This transfer will ensure the widest possible dissemination of information.
IMPORTANT: When page proofs of the accepted manuscript are made and sent to authors, this is in order to check that no undetected errors have arisen in the typesetting (or file conversion) process. Only printers' errors may be corrected; no changes in, or additions to, the edited manuscript will be accepted. In the case of extended changes, the authors will be required to pay part of the extra costs involved.
Electronic manuscripts
The publisher welcomes the receipt of an electronic version of your accepted manuscript. If there is not already a copy of this (on diskette) with the journal editor at the time the manuscript is being refereed, you will be asked to send a file with the text of the accepted manuscript directly to the Publisher by e-mail or on diskette (allowed formats 3.5" or 5.25" MS-DOS, OR 3.5" Macintosh) to the address given below. Please note that no deviations from the version accepted by the Editor of the journal are permissable without the prior and explicit approval of the Editor. Such changes should be clearly indicated on an accompanying printout of the file.
Author benefits
No page charges. Publishing in Journal of Non-Crystalline Solids is free.
Free offprints. The corresponding author will receive 25 offprints free of charge. An offprint order form will be supplied by the publisher for ordering any additional paid offprints.
Discount. Contributors to Elsevier Science journals are entitled to a 30% discount on all Elsevier Science books.
Further information (after acceptance)
Elsevier Science B.V.
Journal of Non-Crystalline Solids
Issue Management
P.O. Box 2759, 1000 CT Amsterdam
The Netherlands.
Fax: +31-20 485 2319
E-mail: g.anderton@elsevier.nl
Editorial Board
Editor:
J.H. Simmons, Journal of Non-Crystalline Solids, Arizona Materials Laboratory, 4715 E Fort Lowell Road, Tucson, AZ 85712 USA
E-mail: info@jncs.org (general information); eMS@jncs.org (electronic manuscript submission) Tel: (+1) 520 322 2970, Fax: (+1) 520 322 2971
Regional Editors:
G. Frischat, Institut für Nichtmetallische Werkstoffe, Technische Universität Clausthal, D-36878 Clausthal-Zellerfeld, Germany
G.N. Greaves, Department of Physics, University of Wales, Penglais, Aberystwyth, Ceredigion SZ23 3BZ, UK
K. Hirao, Faculty of Engineering, Kyoto University, Sakyo-ku, Kyoto, Japan
H. Hosono, Tokyo Institute of Technology, Materials and Structures Laboratory, 4259 Nagatsuta, Midori-ku, Yokohama 226, Japan
K.F. Kelton, Department of Physics, Washington University, Box 1105, One Brookings Drive, St Louis, MO 63130, USA
J. Lucas, Laboratoires des Verres et Céramiques, Universit?de Rennes I, Ave. du Général Leclerc, Campus de Beaulieu, 35042 Rennes cedex, France
Editorial Advisory Board:
R.M. Almeida, Lisbon, Portugal
G.J. Andriaenssens, Heverlee-Leuven, Belgium
V.I. Arbuzov, St. Petersburg, Russia
S.R. Elliott, Cambridge, UK
G. le Flem, Pessac, France
S.W. Freiman, Gaithersburg, MD, USA
Fuxi Gan, Shanghai, China
D.L. Griscom, Washington, DC, USA
J. Hafner, Vienna, Austria
D.L. Kinser, Nashville, TN, USA
O.V. Mazurin, St. Petersburg, Russia
D.R. McKenzie, Sydney, Australia
A. Montenero, Parma, Italy
U.-C. Paek, Kwangju, South Korea
B.G. Potter, Albuquerque, NM, USA
C. Rüssel, Jena, Germany
G.W. Scherer, Princeton, NJ, USA
N. Soga, Hikon, Japan
K. Tanaka, Ibaraki, Japan
M. Tomozawa, Troy, NY, USA
L.M. Torell, Gothenburg, Sweden
A.K. Varshneya, Alfred, NY, USA
R.A. Weeks, Nashville, TN, USA
M.C. Weinberg, Tucson, AZ, USA
A.C. Wright, Reading, UK
J.M. Wu, Hsinchu, Taiwan
E.D. Zanotto, San Carlos, Brazil
|
刊名字顺( Alphabetical List of Journals):
返回页首 