期刊名称：MEMBRANE WATER TREATMENT
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
ISSN: 2005-8624(Print), ISSN: 2092-7037(Online)
 Impact factor:0.317(2012)
| Aims and Scope |
| The Membrane Water Treatment(MWT), An International Journal, aims at opening an access to the valuable source of technical information and providing an excellent publication channel for the global community of researchers in Membrane and Water Treatment related area. Specific emphasis of the journal may include but not limited to; the engineering and scientific aspects of understanding the basic mechanisms and applying membranes for water and waste water treatment, such as transport phenomena, surface characteristics, fouling, scaling, desalination, membrane bioreactors, water reuse, and system optimization. |
Instructions to Authors
Instructions to Authors
|
| 1. Submission of the paper |
| Authors are asked to submit manuscripts in PDF format electronically through the Techno-Press Manuscript Upload System (TeMUS) (http://www.techno-press.org/papers). Exceptionally, the special issue papers may be directly submitted to the Guest Editor. If you have difficulties in using TeMUS, please contact us at[technop3@chol.com]. On receiving submitted papers, the system will issue the paper ID and Password to the corresponding author which may be conveniently used to check the status of submitted papers. |
| 2. Preparation of the manuscript |
General : The manuscripts should be in English and typed with single column and single line spacing on single side of A4 paper. Submitted papers will be published in three categories, i.e., 1) Regular technical paper, 2) Review papers and 3) Discussions. The first page of an article should contain; (1) a title of paper which well reflects the contents of the paper (Arial, 16pt), (2) all the name(s) and affiliations(s) of authors(s) (Arial, 12pt), (3) an abstract of 100~250 words (Times New Roman, 11pt), (4) 5-10 keywords following the abstract, and (5) footnote (personal title and email address of the corresponding author (required) and other authors' (not mandatory)). The paper should be concluded by proper conclusions which reflect the findings in the paper. The normal length of the technical paper should be about 14-20 journal pages. There will be no page charges and no other fees unless the author wishes arrangements to provide an open access to his article. Authors are advised to read the details in the Appendix A for guide, Appendix B for a template and Appendix C for index of the instructions to authors for the format of the first page of the paper.
Tables and figures : Tables and figures should be consecutively numbered and have short titles. They should be referred to in the text as following examples (e.g., Fig. 1(a), Figs. 1 and 2, Figs. 1(a)-(d) / Table 1, Tables 1-2), etc. Tables should have borders (1/2pt plane line) with the captions right before the table. Figures should be properly located in the text as an editable image file (.jpg) with captions on the lower cell. All of the original figures are required at the end of the manuscript for reference in editing.
Units and mathematical expressions : It is desirable that units of measurements and abbreviations should follow the System Internationale (SI) except where the other unit system is more suitable. The numbers identifying the displayed mathematical expression should be placed in the parentheses and referred to in the text as following examples (e.g., Eq. (1), Eqs. (1)-(2)). Mathematical expressions must be inserted as an object (set as Microsoft Equations 3.0) for Microsoft Word 2007 and after versions. Image-copied text or equations are not acceptable unless they are editable. The raised and lowered fonts cannot be used for superscription and subscription.
References : A list of references which reflect the current state of technology in the field locates after conclusions of the paper. For details to prepare the list of references and cite them in the text, authors are advised to follow the introduction and the sample list in the Appendix A and Appendix C of the instruction. |
| 3. Review |
| All the submitted papers will undergo a peer-review process, and those papers positively recommended by at least two expert reviewers will be finally accepted for publication in the Techno-Press Journals or after any required modifications are made. |
| 4. Proofs |
| Proofs will be sent to the corresponding author to correct any typesetting errors. Alterations to the original manuscript will not be accepted at this stage. Proofs should be returned within 48 hours of receipt. |
| 5. Copyright |
| Submission of an article to a Techno-Press Journal implies that it presents the original and unpublished work, and not under consideration for publication elsewhere. On acceptance of the submitted manuscript, it is implied that the copyright thereof is transferred to the Techno-Press. The Transfer of Copyright Agreement may also be submitted. |
*Appendix A. Authors' Guide
*Appendix B. Template
*Appendix C. Index
Editorial Board
| Editorial Board |
Dr. SP Agashichev
ADWEA-Research Center
United Arab Emirates
Prof. AL Ahmad
School of Chemical Engineering
Univ Sains Malaysia, Malaysia
Dr. RB Aim
IFTS
France
Dr. AE Al-Rawajfeh
EOSRC
Tafila Technical University, Jordan
Prof. CP Borges
COPPE
Univ. Federal do Rio de Janeiro, Brazil
Prof. A Bottino
Dept of Chemistry and Industrial Chemistry
Univ of Genoa, Italy
Prof. WR Bowen
i-NewtonWales, UK
Prof. CY Chang
Dept of Environmental Engn & Science
Chia Nan Univ of Pharmacy & Science, Taiwan
Prof. TS Chung
Dept of Chemical and Environmental Engn
National Univ of Singapore, Singapore
Prof. P Fievet
Equipe "Nanosciences, Capteurs, Membranes"
Institut UTINAM (UMR CNRS 6213), France
Prof. V Geraldes
Dept of Chemical and Biological Engn
Technical Univ of Lisbon, Portugal
Prof. R Ghosh
Dept of Chemical Engn
McMaster Univ, Canada
Prof. M Gryta
Inst. of Chemical Tech & Environm Engn
West Pomeranian Univ of Tech, Szczecin, Poland
Prof. A Higuchi
Depf of Chemical & Materials Engn
National Central Univ, Taiwan
Dr. Nick Hankins
Dept of Engineering Science
The University of Oxford, UK
Prof. AF Ismail
Advanced Membrane Tech Research Center
Universiti Teknologi Malaysia, Malaysia
Prof. M Khayet
Dept of Applied Physics I
Univ Complutense of Madrid, Spain
Prof. KC Khulbe
Dept of Chemical Engn
Univ of Ottawa, Canada
Prof. S Koter
Faculty of Chemistry
Nicolaus Copernicus Univ, Poland
Prof. Y Kiso
Dept. Ecological Eng
Toyohashi Univ. of Technology, Japan
Prof. I Koyuncu
Dept of Environmental Engn
Istanbul Technical Univ, Turkey
Prof. JH Kweon
Dept of Environmental Engn
Konkuk University, Korea
Prof. P Le-Clech
Chemical Science and Engn
The Univ of New South Wales, Australia |
Prof. W Lee
Dept of Civil & Environmental Engn
KAIST, Korea
Prof. XF Li
Key Lab of Hollow Fiber Membrane Materials
and Membrane Process of Ministry of Education
Tianjin Polytechnic Univ, China
Prof. B Liao
Department of Chemical Engineering
Lakehead University, Canada
Prof. F Macedonio
University of Calabria
Rende 87036, Italy
Prof. R Molinari
Dept of Chemical Engn and Materials
Univ of Calabria, Italy
Prof. HY Ng
Division of Environ. Science and Eng.
National Univ. of Singapore, Singapore
Prof. LD Nghiem
Sch Civil Min & Environm Engn
Univ Wollongong, Australia
Prof. Z Palaty
Dept of Chemical Engn
Univ of Pardubice, Czech Republic
Prof. M Pontie
GEPEA
UMR-CNRS 6144, France
Prof. AB Ribeiro
Dept de Ciencias e Engenharia do Ambiente
Faculdade de Ciencias e Tecnologia, Portugal
Prof. A Schafer
Dept. of Environmental Eng.
The University of Edinburgh, UK
Prof. HK Shon
Faculty of Engn
Univ of Technology, Sydeny, Australia
Prof. P Sridang
Dept. of Civil Engineering
Prince of Songkla Univ, Thailand
Prof. A Szymczyk
Chimie et Ingenierie des Procedes
Universite Rennes 1 - ENSCR, France
Dr. Y Tanaka
IEM Research, Japan
Prof. M Turek
Faculty of Chemistry
Silesian Univ of Technology, Poland
Prof. ZB Ujang
Fac of Chemical & Natural Resources Eng
Univ Teknologi Malaysia, Malaysia
Prof. B Van der Bruggen
Dept of Chemical Engn
K.U. Leuven, Belgium
Prof. C Visvanathan
Sch of Environment, Resources and Development
Asian Institute of Technology, Thailand
Prof. Z Wang
Sch of Chemical Engn and Technology
Tianjin Univ, PR China
Prof. TW Xu
Sch of Chemistry and Materials Science
Univ of Sci. & Tech. of China (USTC), PR China
Prof. HM Yeh
Dept of Chemical and Materials Engn
Tamkang Univ, Taiwan
Prof. G Zhang
College of Environmental and Energy Engn
Beijing Univ of Technology, China
|
|
