期刊名称：JOURNAL OF THE CHINESE SOCIETY OF MECHANICAL ENGINEERS
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
The object of the Journal of Chinese Society of Mechanical Engineers is to serve as a vehicle for the communication of original research results of permanent interest in all fields of mechanical engineering. The Journal especially welcomes papers that are related to recent technological advances.
The contributions, which may be analytical, experimental or numerical, should be of significance to the progress of mechanical engineering. The majority of the papers published in the journal are full-length articles of considerable depth. Another important format is the Technical Brief, which is intended to serve as a means for the rapid communication of recent developments in an abridged form. Comments on published papers may be submitted in the form of discussion, which is subject to a rebuttal by the author.
Instructions to Authors
The Journal of the Chinese Society of Mechanical Engineers publishes original research papers on all phases of mechanical engineering and related fields in applied sciences. All papers submitted are refereed by experts who will advise the Editor on the matter of acceptance on the basis of merit, originality and length of the paper. Only those papers that are highly recommended will be accepted, and this Journal reserves the right to accept the paper either as a full paper or as a research note. A research note is similar in form to full paper, but, presents material of a brief nature or restricted scope. Four copies of manuscripts should be submitted to the Editor-in-Chief: Prof. Chao-Kuang Chen; Department of Mechanical Engineering, National Cheng Kung University, Tainan, Taiwna, 701, R.O.C. Manuscripts are reviewed with the understanding that the same work has not been and will not be published nor is presently submitted elsewhere. If the paper is accepted, the author will be responsible for proof-reading. There is a page charge of NT$ 2,000 per additional page exceeding the page length requirement.
In addition to being concise and consistent in style, spelling and the use of abbreviations, the paper should conform to the following instructions. |
1. Language:
Papers should be written in English. Each paper should have abstracts (not exceeding 150 words) in both Chinese and English. For the author unfamiliar with Chinese, he may only submit the English abstract which will be translated into Chinese by the editor of this Journal.
2. Units:
The SI units should be followed for all dimensional quantities.
3. Typescript:
Manuscripts should be typed, double-spaced, on standard white paper measuring 21 cm ?30 cm（A4 format）.
4. Title & Author:
The title of the paper should be concise, informative and in capital letters. The author name, title and affiliation should appear below the title.
5. Keywords:
Several keywords (not more than 4 words) for the title of the paper should be given below the author name and affiliation.
6. Headings:
Headings for sections should be centered on the page without numbering Headings for subsections, which can be numbered, should start from the left-hand margin.
7. Equations and Mathematical Formulas:
All equations and mathematical formulas should be typewritten or written clearly in ink. Equations should be numbered serially on the righthand side by Arabic numerals in parentheses. Leave as much space as possible above and below all of the mathematical expressions.
8. Length:
The test of a full paper normally should not exceed 8,000 words (10 printed pages in the Journal) or equivalent. A research note normally should not exceed 3,200 words (4 pages) or equivalent.
9. Figures:
Once the paper is accepted, the author should promptly supply original copies of all of the illustrations, line drawings drafted in ink on white or drawing paper (or "glossies";), and photographs on glossy papers. All illustrations, photographs, tables, etc. should be numbered, titled and have descriptive captions. The figure number and author’s name should be clearly indicated on the reverse side of each illustration. The lettering, typed or in engineering type, should be large enough so that when reduced, it will still be legible.
10. Nomenclature:
All symbols and units should be listed in English and in alphabetical order with indication of their meaning and dimensions.
11. References:
Chu, S., and Wang, C.S., "TITLS,"; CSITR-668-72, Chung Shan Institute of Science and Technology, Lungtan, Taiwan (1977).
Etkin, B., Dynamics of Atmospheric Flight, John Wiley and Sons, New York, N.Y., pp. 166-188(1970).
Hsiao, C.H., "TITLE,"; Ph. D. Thesis, Department of Electrical Engineering, National Cheng Kung University, Tainan, Taiwan (1974).
Morris, J.G., and Howard, K.K., "Thermomechanical Treatments of Alloys,"; J. Appl. Physics, Vol. 42, No. 1, pp. 32-325(1971).
Pfalt, J.L., and Rosenfeld, A., "TITLE,";, Proc., of First International Joint Conference on Artificial Intelligence, Washington, D.C. (1969).
|
Editorial Board
Editor-in-Chief: C.K.Chen(陳朝光)
Department of Mechanical Engineering
National Cheng Kung University
Tainan, Taiwan 70101, Republic of China
Tel:886-6-2757575 ext. 62140
Fax:886-6-2352973, 886-6-2342081
E-mail:ckchen@mail.ncku.edu.tw
Executive Editor: J.J. Hwang(黃鎮江)
Graduate Institute of Greenergy Technology
National University of Tainan
Tainan, 700, Taiwan
Tel:886-6-2606198(Chair's Office)
Fax:886-6-2602596
Email:azaijj@mail.nutn.edu.tw
Executive Editor: Chieh-Li Chen(陳介力)
Department of Aeronautics and Astronantics
National Cheng Kung University
Tainan, 701, Taiwan
Tel:886-6-2757575 ext. 63678(Chair's Office)
Fax:886-6-2766549
Email:chiehli@mail.ncku.edu.tw
Editorial Board
Foreign Editors
|
| Ta-Shen Chen |
|
University of Missour-Rolla, USA |
| Ampere A. Tseng |
|
Arizona State University, USA |
| MingKing K. Chyu |
|
Carnegie Mellon University, USA |
| Tom I-P, Shih |
|
Michigan State University |
| John, W. Cleaver |
|
University of Liverpool, U. K |
| Siew Hwa Chan |
|
Nanyang Technological Univerisity, Singaporre |
| Hongtan Liu |
|
University of Miami, U. S. A. |
| TYe-tai Fei |
|
Hefei University of Technology PRC |
| Domestic Editors |
| K. S. Wang(王國雄) |
|
National Central University |
| J.J. Wang(王俊志) |
|
National Cheng Kung University |
| C. C. Wang(王啟昌) |
|
Hsing Kuo University |
| J.H. Kuang(光灼華) |
|
National Sun Yat-sen University |
| C.J. Ho(何清政) |
|
National Cheng Kung University |
| L.Y. Wu(吳隆庸) |
|
National Tsing Hua University |
| C. C. Wang(汪正祺) |
|
Far East University |
| W.S. Lee(李偉賢) |
|
National Cheng Kung University |
| S.Y. Lee(李森墉) |
|
National Cheng Kung University |
| R.S. Lee(李榮顯) |
|
National Cheng Kung University |
| J.H. Chou(周至宏) |
|
National Kaohsiung First University of Science and Technology |
| H.M. Chou(周煥銘) |
|
Kun Shan University |
| T.H. Lin(林大惠) |
|
National Cheng Kung University |
| J. F. Lin(林仁輝) |
|
National Cheng Kung University |
| P.D. Lin(林昌進) |
|
National Cheng Kung University |
| Z.C. Lin(林榮慶) |
|
National Taiwan University of Science and Technology |
| C.R. Lin(林啟瑞) |
|
National Taipei University of Technology |
| C.I. Hung(洪振益) |
|
National Cheng Kung University |
| C.Y. Hong(洪振義) |
|
Nan Kai Insititute of Tainan |
| C. W. Hong(洪哲文) |
|
National Tsing Hua University |
| H.C. Weng(翁輝竹) |
|
Chung Yuan Christian University |
| C.W. Chang-Jian(張簡才萬) |
|
I-Shou University |
| K. M. Chang(張國明) |
|
National Kaohsiung University Applied Sciences |
| M. Chang(章明) |
|
Chung Yuan Christian University |
| C.H.Kuo(郭正雄) |
|
National Chung Hsing University |
| R.F. Fung(馮榮豐) |
|
National Kaohsiung First University of Science and Technology |
| W.M. Hwang(黃文敏) |
|
National Cheng Kung University |
| J. H. Huang(黃錦煌) |
|
Feng Chia University |
| C.Y. Yang(楊慶煜) |
|
National Kaohsiung University of Applied Science |
| T.M. Liou(劉通敏) |
|
National Tsing Hua University |
| C.H. Liu(劉建宏) |
|
National Formosa University |
| Tsai, Y. C(蔡穎堅) |
|
Cheng Shiu University |
| C.C. Cheng(鄭志鈞) |
|
National Chung Cheng University |
| C. H.Cheng(鄭金祥) |
|
National Cheng Kung University |
| C.Y. Cheng(鄭慶陽) |
|
Southern Taiwan University of Technology |
| T. N. Shiou(蕭庭郎) |
|
National Cheng Kung University |
| H.Y. Lai(賴新一) |
|
National Cheng Kung University |
| W.Y. Jywe(覺文郁) |
|
National Formosa University |
|
